Activate IP Camera with SADP and Add IP Camera to NVR over the Network

Step 1: Install the SADP Application from the link below. 

https://app.box.com/s/dmix8r9t0exurvagtg3jxth0jscy5aog

Step 2: Make sure that either the computer/laptop is in the same network as the switch or the computer is connected to the same switch as the devices.

Step 3: The SADP application will list the “Inactive” devices connected to the switch as shown in the figure below.

Step 4: Select the “Inactive” devices by checking the box next to the Device Type. Create a “New Password” and “Confirm password”

(Note: It is recommended to use the same password as the NVR)

Step 5: Click on “Confirm” to finish activating the devices.

Step 6: Click “Refresh” before proceeding with the step.

Step 7: Assigning IP Addresses to activated devices.

• Select each device individually and input the desired IP Address 
  
• Input the password
  
• Click “Modify”
  
• Repeat the steps for all the activated devices. The IP address has to be unique for each device.
  

Step 8: Adding the activated devices into the NVR over network.

• Make sure the NVR and the devices are in the same network
  
• On the NVR local menu, right click and select Menu  Camera  Camera  IP Camera
  
• Click on the notepad icon next to a channel we want to add the camera.
  
• Change the adding method to Manual.
  
• Type in the IP address of the IP Camera activated on the SADP application\
  
• Input the password and click “OK”